Install the indoor unit balanced
Check that the access doors have removable corner covers to install the indoor unit without removing the panel. It also makes it easier to service and install.
Checking the drain trough
Remove the corner cap to check. The new design allows checking the water pump without removing the panel. Locating the water trough's drain hole is also simple.
Drain pump 850 mm
The drain pump is pre-installed with an 850mm pipe lift to facilitate pipe routing. Installation is also made simple by a 185mm soft tube, a standard accessory, and a location.
The flaps control system
The wired controller can control the flaps from high to low independently. (This control system also works on FDE ceilings.)
*The remote controller or the RCH-E3 applies no flap control.